Resources & Documents

  • This document (EN 546-2:2006) has been prepared by Technical Committee CEN/TC 132 “Aluminium and aluminium alloys”, the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by June 2007, and conflicting national standards shall be withdrawn at the latest by June 2007. This document supersedes EN 546-2:1996. Within its programme of work, Technical Committee CEN/TC 132 entrusted CEN/TC 132/WG 6 \"Foil and finstock\" to revise EN 546-2:1996.

  • This standard is issued under the fixed designation B209M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval.

  • Aluminium and aluminium alloys - Foil - Part 3: Tolerances on dimensions

  • This document specifies the technical conditions for inspection and delivery of wrought aluminium and aluminium alloy foil. The gauge range covered is 6 m to 200 m. It does not apply to lacquered, painted, embossed or laminated products.

  • Aluminium and aluminium alloys — Sheet, strip and plate Part 1: Technical conditions for inspection and delivery

  • Aluminium and aluminium alloys — Sheet, strip and plate — Part 3: Tolerances on dimensions and form for hot-rolled products